Positioning pins for automotive inspection tools:

-The position of the positioning hole is determined by the RPS system on the part drawing (usually two positioning holes are set for each part)- The positioning pin consists of three parts: guide, positioning, and handle, ensuring that the guide part of the pin can enter and exit freely in the positioning hole

-Marking of positioning pins: Mark the pin brand and corresponding RPS point name in the concave groove of the handle

-According to the RPS characteristics of the part, the positioning pin is correspondingly set as a conical pin and a cylindrical pin,

-In the positioning hole, to ensure accurate positioning of the positioning pin, it is necessary to install a guide shaft sleeve, which is bonded to the gauge body.

-The positioning accuracy of the center of the guide sleeve relative to the vehicle coordinate line is controlled within/-0.05mm.

-The structure of the positioning pin and corresponding guide shaft sleeve is divided into anti rotation structure and non rotation structure according to the different requirements of the hole shape,

-Each positioning pin configuration Ф 3mm nylon rope and fix it to the appropriate part of the gauge body.

-Placement of the sales box: After use, the positioning pin and inspection pin should be placed inside the sales box and clamped with a clamp. The sales box is placed on the side of the inspection tool body and in an appropriate position on the upper part of the bottom plate.

-In the fixture drawings, clear descriptions must be provided for the positioning pins and holes.